APPLICATION
- Carefully remove the lash from the eyelash tray, grasping it from the band to avoid pulling the mink hair. Align the lash to your natural lash line to check the lash fit. If it extends past the outer corner of your eye, trim the excess.
- Apply a thin layer off lash glue on the lash band and allow 30-60 seconds to dry.
- Tip: Use a tweezer to apply the lash as close to your natural lash line as possible
- Hold it down for a few seconds to make sure the lash is nice and secured.
LASH CARE
- Avoid applying mascara directly to your mink lash as it may damage the mink hair. Instead, apply mascara to your natural lash, allow for it to dry, and then apply your mink lashes.
- After wear, carefully remove any excess glue with your fingers. You can use tweezers but be careful not to pull too much of the band as it can ruin the band.
- SAY NO TO SOAKING! Glue can sometimes be stubborn to come off but soaking your lashes in makeup remover, water, or alcohol can damage the lash. Instead, run a damp cotton swab across the band to loosen and remove the glue.
- Make sure to store your lashes in it's box to keep them clean, free of any dust or bacteria. This also helps them keep it's true form.